The driver's seat was set back slightly after Laurel had sewed in one side of the seat-back zips. She realised that she hadn't used a "zipper foot" on the passenger seat, so she will have to unpick the driver's zip and re-do it. That and me stuffing my back moving a set of drawers (my back nearly better), meant that the last two days of my week off were not productive.
I did manage to crawl under the car and plan the route for the heater wiring. It can't run near any low voltage or signalling wires as it will radiate a bit of noise and I was concerned that there wasn't a suitable path for it - there is! I also pulled the heater apart again and added some extra mica sheet insulation around the inside of the box to protect the high voltage wiring from arcing to ground. I'm getting a bit paranoid about DC arcing - fuses or not.
More soon.
No comments:
Post a Comment